英國CLASS的CARGO-SAFE艙口蓋超聲波泄漏儀特點和優勢

The Cargo-Safe and Door-Safe receivers unparalleled performance.

The signal from the ultrasonic transmitter is a bi-tone, slightly above and slightly below 40 kHz. Therefore, the receivers must exclusively capture these two very close frequencies. Any other frequencies produced by machinery, welding, repair work, or possibly from fluorescent lighting, must be rejected by the receiver. Any noise interference would show up on the receiver's display and be heard in the headphones which increases the display reading above the true value and obscuring the transmitter's bee-boo sound in the headphones. When the signal to the receiver is weak the display error can be significant. for instance at the critical time when readings are being taken from the closed hatch cover. Consequently, it is essential that the receiver only registers the transmitter sound and nothing else. The Class Instrumentation receiver has a unique capability to filter out all other sounds outside the transmitter's precise frequency range of 40 kHz, making it unparalleled in recording reliable and error-free results; essential requirements for an error free ultrasonic receiver.

貨物保險箱和門保險箱具有無與倫比的性能。

超聲波發射器的信號是雙音，略高于和略低于40kHz。因此，接收器必須專門捕獲這兩個非常接近的頻率。接收器必須拒絕機械、焊接、維修工作或熒光燈產生的任何其他頻率。任何噪聲干擾都會出現在接收器的顯示器上，并在耳機中聽到，這會使顯示器讀數高于真實值，并掩蓋耳機中發射器的蜂鳴聲。當接收器的信號較弱時，顯示錯誤可能會很大。例如在從關閉的艙口蓋讀取讀數的關鍵時刻。因此，接收器必須只記錄發射器的聲音，而不記錄其他聲音。Class Instrumentation接收器具有獨特的能力，可以過濾掉發射器40 kHz頻率范圍之外的所有其他聲音，使其在記錄可靠和無誤差的結果方面無與倫比；無誤差超聲波接收器的基本要求。

Transmitter Emitter testers for hatch-cover testersare crucial for ensuring accurate measurements.These transmitters employ multiple emitters to create a uniform spread of ultrasound. Each emitter must operate at maximum power to produce this even distribution. The uniform spread of ultrasound is essential to ensure consistent energy levels impact the entire hatch-cover seal. This consistency allows the open-hatch value (OHV) to be measured anywhere around the hatch-cover, yielding reliable decibel readings. The pass/fail criteria for hatch-cover seals are standardised at 10% of the OHV. Thus, it is vital that each emitter functions at maximum power to maintain consistent ultrasound throughout the ship's hold.

Testing the output of each emitter requires individual assessment using a calibrated emitter tester. Class Instrumentation Ltd includes a dedicated emitter tester in their Cargo-Safe hatch-cover testing kit. This tester is used before each survey to verify the transmitter's proper operation, ensuring compliance with all hatch-cover testing regulations. Class Instrumentation Ltd provides these essential tools.

艙口蓋超聲波泄漏儀的發射器---發射器對于確保準確測量至關重要。

這些發射器采用多個發射器來產生均勻的超聲波傳播。每個發射器必須以功率運行，以產生這種均勻的分布。超聲波的均勻傳播對于確保一致的能量水平影響整個艙口蓋密封至關重要。這種一致性允許在艙口蓋周圍的任何地方測量打開艙口值（OHV），從而產生可靠的分貝讀數。艙口蓋密封件的合格/不合格標準標準為OHV的10%。因此，至關重要的是，每個發射器都以功率工作，以在整個船艙內保持一致的超聲波。

測試每個發射器的輸出需要使用校準的發射器測試儀進行單獨評估。Class Instrumentation有限公司在其貨艙